Please send us an e-mail, and a picture, to tell us what your group is doing!

Previous Group • Next Group

How to make a Pen
Featured on this page is Greg Lobko, a student at North Penn High School, Lansdale, PA, demonstrating the steps on how to make a wood pen using Penn State Industries products. We would like to thank his woodshop teacher, Bill Michael, for taking and sending us these photographs.
	Step 1 - Cut & Drill Wood Blanks. Cut blanks to the length of the tube plus 1/16". Drill a centered hole through each blank.
	Step 2 - Glue the Tubes into the Blanks. Spread the glue on the tube. Insert the blank with a twisting motion to spread glue evenly inside. Allow to dry.
Step 3 - Turning The Blanks. Set up the lathe according to manufacturer’s directions. Using chisels turn blanks to desired diameter.
Step 4 - Sand. As with any sanding, progress through a range of grits	Step 5 - Finish. Try a finish of your choice, for example, PSI Liquid Friction Polish.	Step 6 - Assembly. Use a clamp, vise or Project Assembly Press to press parts together.
Greg's finished pen

Toll Free Ordering: 1-800-858-9295
Toll Free Assistance: 1-800-847-8984